FPV kamera med innebygget sender i kraftig hus som tåler en trøkk, og er beskyttet mot vann og støv.
Integrated camera and 25mw transmitter
Protective outer shell for extreme durability
Water, shock and dust resistant
Excellent image clarity in all lighting conditions
Enough signal range for small park flyers and quad racers
Compatible with 5.8GHz Fat Shark headsets
Powered separately or through modeler's receiver
Remote channel selection available when powered through receiver aux port
Integrated power filter prevents motor and servo interference
No 2.4GHz RC interference
HAM license required for U.S. operation
Installs in seconds
Needed To Complete
Open Port on Receiver or Y Harness
5.8GHz FPV Headset or Monitor
3.9-6.0 Volt Power Source
The VA2510 is built for applications like FPV quad racers or surface vehicles where extra protection from shock and the elements is needed. Its camera and 25mw, 5.8GHz transmitter are housed in a protective shell that's barely bigger than a thimble. It can be powered separately or through the model's receiver. Powering it separately requires a 3.9-6.0 Volt Power Source
If powering the VA2510 through an auxiliary channel on your receiver, its integrated power filter will prevent interference from the model's motor and servos. You can also assign a transmitter switch or dial to whatever aux channel the camera is connected to and remotely change video frequencies.
The VA2510 is compatible with all 5.8GHz Fat Shark headsets and can be installed in minutes. A HAM license is required for to operate the VA2510 in the U.S.
† A HAM license is required for to operate the VA2510 in the U.S.
Frequency Band: 5.8GHz
Modulation: Analog NTSC
Input power: 3.9v - 6.0v
Signal output: 25mw